TECHNIQUE

Start with the lateral claw of the hind feet or the medial claw of the front foot.


 

Measure from Coronary band to tip of toe and snip tip of toe off right at 3 inches.


Use hoof knife to flatten walking surface of the toe.  The walking surface is where the white line starts on the axial part of the hoof. 


Use hoof knife to blend-in the lateral aspect of the sole over the white line.  Remember to keep it as flat as possible.

Try to stay away from the heel area.  It is important to conserve as much heel as possible.


Now that a blueprint has been made with the first claw trimmed, use this blueprint to start trimming the opposite claw.

Again, tip the toe off at 3 inches.


Again, flatten the toe making sure to identify where the white line begins at the axial part of the claw.


Trim the lateral aspect of the claw making sure to blend the toe area.  Remember to keep it as flat as possible.

Again try to stay way from the heel area.  It is important to conserve as much heel as possible.


Balance the heels.

Make sure not to over trim and remove too much heel.


Open the toes by trimming away sole near the interdigital space of the heel.

Make sure not to remove too much sole by concaving a wide area.

 

 

Copyright 1999-2001
New Bolton Center Field

Service
Department
Students:  Keith Javic - Class of 2003, C. Nikki Conroy - Class of 2003

 

PortalMore Ads
Trust Rating
Biz Rating
72%
Loading
cal.vet.upenn.edu
Close
PortalMore Ads
Close